Contact

ADDRESS

 No.58 Volvo Road Economic Development Area,Linyi City,China
 

E-MAIL
 info@plymachine.com

 

TELEPHONE

  +86-539-6017997 6017977
 +86-539-6017787

How to control the thickness of the veneer when the rotary cutter is working

Views: 1     Author: Site Editor     Publish Time: 2023-07-14      Origin: Site

The use of veneer peeling machine can process the wood, improve the utilization rate of wood, and save production costs.

Due to the different thickness of plywood required by different customers, it is required to adjust the rotary cutting machine according to the actual situation when spinning the wood, in general, the rotary cutting machine is set in accordance with the thickness of 1-2 mm before the factory. Later, if you want to change the thickness of wood skin, first adjust the pressure of the rotary cutting machine, use a triangle rule against the upper and inner side of the rotary cutting machine double roller, use a 150mm straight rule against the above of the single roller to observe the value of the intersection between the bottom of the triangle rule and the ruler, when the skin thickness is 1 to 2 mm, take 35 to 36 mm, if the thickness of the leather is less than 1 mm, read the value accordingly. If the thickness of the leather is greater than 2 mm, the reading value decreases accordingly.

If you want to increase the pressure of the veneer peeling machine, to the two sides of the single box and the shoulder between the knife pad; When the pressure is reduced, reduce the gasket.


Contact us

CONTACT US

 Company: Shandong Jinlun Machinery Co,Ltd. 
 Tel: +86-539-6017977
 Fax: +86-539-6017787
 Email: info@plymachine.com
 Address: No.58 Volvo Road Economic Development Area,Linyi City,China
INQUIRY

PRODUCT CATEGORY

 Copyright © 2023 Shandong Jinlun Machinery Manufacturing Co,Ltd.    All Rights Reserved